en
3. Introduction
These compressor nebuliser systems are designed to deliver a fine aerosol mist from the liquid
medication prescribed by your doctor to treat your respiratory condition.
Use according to the instructions given by your doctor or physician.
Please read the instructions carefully to obtain the maximum benefit from the compressor
nebuliser systems.
The compressor nebuliser systems are approved for the following environmental / ambient
conditions for transportation, use and storage purposes:
3.1 Storage
The machine should be stored in a dust and smoke-free area.
Recommended: 0˚c - 40˚c
RH: 15% - 95%
Pressure: 950hPa - 1020hPa
WARNING: Do not use compressor nebuliser systems near active high frequency surgical
equipment or electro-magnetic equipment.
4. Starter kits
The Turboneb 2 is not supplied with a starter kit.
The Turboneb 2 supplies the highest flow rate for nebulising viscous antibiotics and has been
designed to operate from mains voltage. Two versions are available, UK and EURO, (i.e. plug type)
both 220-240V /50Hz.
This compressor-only unit provides flexibility for the user to choose the most appropriate accessories
for demanding applications.
Note:
•
Both Econoneb and Turboneb 2 are continuously rated for repetitive use.
Please refer to the information label on the machine to establish that you have the correct
voltage for your mains supply.
•
The parts listed above are required for correct function of this compressor nebuliser and
must be in compliance with EN 13544-1.
4
are supplied with the AC2000 and Econoneb containing:
1
x medication chamber
1 x inlet filter
1
x mouthpiece
1
x child face mask
1
x driveline
1 x filter spanner
1
x adult face mask