Administrating The Medication; Cleaning; Changing The Attachments - Clement Clarke International MEDIX AC2000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
en
6.2 Administering the Medication
Switch the compressor unit on. Sitting in an upright relaxed position, place mouthpiece into the
mouth (or face mask over the nose and mouth) and start breathing slowly and deeply. Do not try to
breathe quickly. If you have any problems seek instruction from your doctor or physiotherapy
department at your hospital. Switch off the compressor nebuliser when the misting has stopped.
Unplug the mains lead.

6.3 Cleaning

In order that you benefit fully from your equipment, it is important that the machine and accessories
are kept in a clean condition. Ensure that the medication chamber is taken apart and washed in warm
soapy water. Rinse and allow to dry after each use. The jet holes should be blown clear by attaching
the chamber to the air outlet from the compressor and running the machine for a couple of minutes.
We advise that the tube is disconnected from both the outlet filter and the chamber after each use to
prolong the life of the connector.
The compressor nebuliser devices are suitable for cleaning daily with approved CE marked
disinfectant wipes for the lifetime of the device.
WARNING: Accessories are not for multiple patient use due to risk of infection.
Device must be cleaned between patients to prevent risk of infection.

6.4 Changing the Attachments

It is recommended that the following disposable items should be changed as follows:
Medication chamber
Inlet filter
Driveline
Face Mask
Mouthpiece
Outlet filter
Only medication chambers supplied or approved by Clement Clarke International should be used.
6
}
change every 3 months
}
change every 12 months

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Medix econonebMedix turboneb 2

Tabla de contenido