Horizon Global 76196 Instrucciones De Instalación página 4

1. Remove the Fascia
a.) Using an 8mm socket, remove (1) screw from the lower rear side of the wheel well.
b.) Using a drill and a 3/16" drill bit, remove the (2) rivets above the screw previously removed on each side of the vehicle.
c.) Using a 10 mm socket, remove the uppermost screw on each side of the vehicle. Furthermore, remove the two 10mm bolts located near the spare tire holding
the fascia to the bumper beam
d.) Pull the wheel well cover slightly outward. Once moved, use a 7mm socket to remove the (1) screw located under the cover from each side of the vehicle.
e.) Using a T30 torx bit, remove the (2) screws located near the brake lights, underneath the fifth door.
f.) Remove the fascia and trim according to figure 2. Note: be sure to keep the lower part of the fascia connected, only trim along the red line.
A
C
©2017 Horizon Global Americas Inc. - Printed in Mexico
B
D
F
Sheet 4 of 18
C
E
76196NP 10-17-17 Rev. A