2. Lower the exhaust using exhaust removal pliers to detach the (2) exhaust
hangers on each side of the vehicle. Note: make sure that the exhaust system is
supported prior to lowering the exhaust. Note: use of spray lubricant may be
useful in removing exhaust hangers.
4. Remove bumper beam. Using a 21mm socket, remove the (3) bolts holding
the bumper beam in on each side of the vehicle. Return bumper beam to
customer.
©2017 Horizon Global Americas Inc. - Printed in Mexico
3. Lower the spare tire by consulting your owners manual.
5. Insert hitch into frame rails and install fasteners. Once hitch is in position,
attach the carriage bolt to the pull wire. Feed the pull wire through the block and
then the frame rail and out the attachment holes. Make sure the blocks are
aligned properly and do not overlap.
Sheet 5 of 18
76196NP
10-17-17
Rev. A