Horizon Global 76196 Instrucciones De Instalación página 6

5. Insert hitch into frame rails and install fasteners. Once hitch is in position,
6. Tighten all 1/2-13 Gr5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
attach the carriage bolt to the pull wire. Feed the pull wire through the block and
then the frame rail and out the attachment holes. Make sure the blocks are
aligned properly and do not overlap. Use cable ties to secure the fascia around
the cross tube.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
7. Raise exhaust back into place and replace fascia by reversing the process in step 1. Use cable ties to secure the fascia around the cross tube.
©2017 Horizon Global Americas Inc. - Printed in Mexico Sheet 6 of 18 76196NP 10-17-17 Rev. A