Connecting Speakers/Subwoofer; Connecting Speaker Cables - Yamaha RX-VTD73 Guía De Configuración Sencilla

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
3

Connecting speakers/subwoofer

• Under its default settings, the unit is configured for 8-ohm
speakers. When connecting 6-ohm speakers, set the unit's
speaker impedance to "6 Ω MIN". For details, see "Setting the
speaker impedance" in "Owner's Manual".
• Use a subwoofer equipped with built-in amplifier.
• Before connecting the speakers, remove the unit's power cable
from the AC wall outlet and turn off the subwoofer.
• Ensure that the core wires of the speaker cable do not touch
each other or come into contact with the unit's metal areas. This
may damage the unit or the speakers. If the speaker cables
short circuit, "Check SP Wires" will appear on the front display
when the unit is turned on.

Connecting speaker cables

Speaker cables have two wires. One is for connecting the
negative (–) terminals of the unit and the speaker, and the
other is for the positive (+) terminals. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminals.
a Remove approximately 10
mm of insulation from the
+ (red)
b
ends of the speaker cable
and twist the bare wires of
the cable firmly together.
– (black)
b Loosen the speaker
terminal.
c Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d Tighten the terminal.
Using a banana plug
(Canada, China and
Banana plug
Australia models only)
a Tighten the speaker
terminal.
b Insert a banana plug into
the end of the terminal.
1
Connect the front speakers (1/2)
to the FRONT (//\) terminals.
ZONE OUT
CENTER
The unit (rear)
ROUND
SUR. BACK
SUBWOOFER
ZONE 2
SURROUND
R
L
c
F R
O N
T
9
a a
d
4
a
F R
O N
T
b
PRE OUT
(SINGLE)
1
2
FRONT
SURROUND
SUR. BACK
SUBWOOFER
CENTER
SPEAKERS
SURROUND BACK
CENTER
FRONT
ZONE 2/F.PRESENCE/
R
L
R
L
R
L
BI–AMP
EXTRA SP
SINGLE
1
2
3
5
2
Connect the center speaker (3) to the
CENTER terminal.
ZONE OUT
PRE OUT
CENTER
(SINGLE)
1
2
The unit (rear)
ROUND
SUR. BACK
SUBWOOFER
ZONE 2
FRONT
SURROUND
SUR. BACK
SUBWOOFER
CENTER
SPEAKERS
SURROUND
SURROUND BACK
CENTER
FRONT
R
L
R
L
R
SINGLE
1
2
9
3
4
ZONE 2/F.PRESENCE/
L
R
L
BI–AMP
EXTRA SP
5
3
En

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rx-a1030Rx-a1020

Tabla de contenido