IN HANDLING THE WATCH
(1) Precautions when diving
!
WARNING
Watches with "DIVER'S 200m" or "DIVER'S WATCH 200m" marked on its
dial or case back are designed to be able to be used when scuba diving
(air diving, water depth of up to 200m).
• This watch is not designed for saturation diving. Do not use this watch
when saturation diving.
• Do not use this watch in water depths of 200m or deeper.
!
CAUTION
[Precautions before diving]
Make sure to do the following before you dive.
• Check that the watch is fully wound.
• Make sure the watch shows the correct time.
• Make sure the rotating bezel is set correctly. Also, make sure that the
watchband is not too loose or too tight.
• Check that the screwed-down type crown is securely tightened.
• Make sure that there are no cracks or chips in the glass.
• Make sure that the watchband is not about to tear, and check that
there are no problems with its joints (spring bar, buckle, clasp, etc.).
If there are any problems, do not use the watch when diving.
!
CAUTION
[Precautions during diving]
• Do not operate the crown while in the water.
• The rotating bezel may be hard to operate under water due to water
pressure.
• Do not subject the watch to shocks, such as banging on rocks.
2