Adjusting The Sound Characteristics; Changing The Sound And Display Settings - Sony CDX-C480 Manual De Instrucciones

Changing the operative direction
The operative direction of controls is factory-
set as in the illustration below.
To increase
To decrease
If you need to mount the rotary commander on
the right side of the steering column, you can
reverse the controls operative direction.
Press (SOUND) two seconds while
pushing the VOL control.
Tip
You can control the operative direction of controls
with the unit.
Adjusting the sound
characteristics
You can adjust the bass, treble, balance and
fader.
Each source can store the bass and treble levels
independently.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n BAS (bass) n TRE
(treble) n BAL (left-right) n FAD (front-
rear)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting.
(After three seconds, the dial functions as
volume control.)
Changing the sound and
display settings
You can set:
•CLOCK (page 7).
•D.INFO (dual information) to display the
clock and the play mode at the same time
(ON) or to display the information
alternately (OFF).
•AMBER/GREEN to change the illumination
color to amber or green.
•DIM (Dimmer) to change the brightness of
the display.
— Select "ON" to dim the display.
•BEEP to turn the beep tones on or off.
•RM (Rotary Commander) to change the
operative direction of the controls of the
optional rotary commander.
— Select "NORM" to use the rotary
commander in the factory preset
position.
— Select "REV" when you mount the
rotary commander on the right of the
steering column.
•A.SCRL (Auto Scroll) (page 15).
Note
If you connect an optional power amplifier and do
not use the built-in amplifier, the beep tone will
be disabled.
1
Press (SHIFT).
2
Press (2) (SET UP) repeatedly until the
desired setting mode appears.
Each time you press (2) (SET UP), the item
changes as follows:
CLOCK n D.INFO* n AMBER/GREEN n DIM
n BEEP n RM n A.SCRL*
* When you have not tune the station or there
is no CD/MD being played, these items will
not appear.
Note
The displayed item will differ depending on
the source.
3
Press (4) (n) to select the desired
setting (for example: ON or OFF).
4
Press (SHIFT).
When the mode setting is complete, the
normal playback mode appears.
EN
13