BEKAWORLD BEKAONE120 Manual De Montaje E Instrucciones De Uso página 25

With the initial filling, air might get entrapped in the
reservoir. These air inclusions do not affect the function
of the pump, but they are transported to the
lubrication point and lubrication may possibly be
delayed or interrupted.
To drain the air, fill the BEKAONE120 during initial filling
slowly up to ca. 1 mm above the marking „max.", till
the sealing lip of the piston slightly opens the ventilation
hole. Then, the air escapes at the overflow hole.
During regular filling, fill the lubricator up to the marking
„max.".
If the BEKAONE120 is used outdoors, you must attach
a membrane sticker over ventilation hole:
1. Fill and ventilate the lubricator.
2. Clean the surface around the ventilation hole and
remove residual lubricant, if necessary.
3. Attach the membrane sticker (see picture).
Membrane sticker for ventilation hole
Order no.: 10100887
Ventilation Follow-up
piston
hole
Air in the
grease
MEMBRANE
EN
06 - Filling
Towards ventilation
-24-