Removing The Front Cover - Yamaha NS-333 Manual Del Usuario

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the four pegs on the inside
surface of the cover with the four corresponding holes on
the speaker and push gently.
Note
When the cover is removed, take care not to touch the speaker
units with your hands or to exert excessive force with tools.
SPECIFICATIONS
Type ............................. 2-way bass reflex speaker system
Driver ...........................................13 cm (5") cone woofer
Frequency response.................................. 60 Hz – 35 kHz
Nominal impedance ............................................... 6 ohms
Nominal input power ................................................ 60 W
Maximum input power ........................................... 150 W
Sensitivity ................................................87 dB/2.83 V/m
Crossover frequency ................................................ 3 kHz
Dimensions (W x H x D) ... 200 mm x 320 mm x 213 mm
Weight...............................................5.5 kg (12 lbs. 2 oz.)
• Specifications subject to change without notice due to
product improvements.
• Care should be taken not to exceed the input power
values noted above.
magnetic shielding type
2.5 cm (1") dome tweeter
(7.9"x 12.6" x 8.4")
3