NEOiD PTZ CAMARA + Manual Del Operador página 108

SAFETY NOTICE-IMPORTANT
The following important notes must be followed carefully to run the
camera and respective accessories in total safety. The camera and
relative accessories are called video system in this section.
Before installing the camera, please read this manual carefully.
Please follow installation instructions indicated in this manual
during installation. Please keep this manual for future use.
The installation should be performed by qualified service
personnel or system installers in accordance with all local rules.
Before powering on the camera, please check the power voltage
carefully. Make sure that you are using the correct power source.
Please put the power cable, video cable and control cable in safe
place.
Do not operate the camera beyond the specified temperature and humidity.
Working temperature range of the camera is between 0℃ and +40℃. The
ambient humidity range is less than 95
During transporting, avoid violent shake or force to the camera.
To prevent electric shock, do not remove screws or housing of the camera.
There are no self-serviceable parts inside. Refer to qualified service personnel
for servicing. ◼Video cable and RS485 cable should be kept far away from
other cables. Shielded and independent wiring is necessary for video and
control cables.
Never aim the lens of the camera at the sun or other extremely bright objects.
Otherwise, it may cause damage.
When cleaning the camera, please use soft cloth. If the camera is very dirty,
wipe it off gently with a soft cloth moistened with a weak solution of water and
a neutral kitchen detergent. Wring all liquid from the cloth before wiping the
camera, then wipe off all remaining dirt with a soft, dry cloth. Use lens cleaning
paper to clean the lens.
R H.
﹪