Remote Controller - NEOiD PTZ CAMARA + Manual Del Operador

When No.5~8 is all ON, camera address, protocol, baud rate, video
format and mounting type can be programmed by OSD menu.
Video format can be programmed via special presets.
NOTE: PTZ reboot is necessary for the new setting to take effect.

REMOTE CONTROLLER

1 HOME
Press HOME button, camera moves to initial
position where both pan and tilt angle is zero
2 CAMERA SELECTION BUTTON
Used to switch among 4 cameras, press 1-4
number buttons to control cameras with 1-4
addresses respectively. For example, press
button 1 to control the camera with address 1
3 FOCUS
Press "AUTO" button to switch to Auto Focus,
press "MANU" button to switch to Manual
Focus mode.