Humisonic - cimuka CT Serie Manual Del Usuario

CT SERIES

Humisonic

TM Automatic Humidity Control
Humidity adjustment in incubators is for providing adequate water loss from eggs. Eggs need to lose between 13-16 % water depending
on the species during incubation period. Weighing your eggs during incubation is the most reliable way to find proper humidity level for
particular poultry species.
Different from temperature, short term humidity changes during incubation are not important. Keeping an average humidity (See Page 27)
during all incubation period is enough to achieve good results. However, high humidity levels during hatching period (last 2-3 day) are
very important. When the chicks start to hatch, inner membrane of egg dries quickly. This makes membranes harden and chick can stick to
shell. To prevent drying of membranes, humidity must be adjusted to high levels depending on species for last 2-3 day of incubation.
Installation
- Connect Humisonic
- Place stainless steel Humisonic
- Use flexible hose to connect Water tank and Humisonic
-
Connect Humisonic
The float valve will keep water level 1 - 2 cm(.39-.79") above water level sensor.
•
CAUTION!
Don't use hard and lime-enriched water for humidifier system and for humidity tray. Change humidifier disks
regularly. Humisonic
service life of unit and power adapter. Never attempt to close air-in hole on Humisonic
TM
reservoir right side of the incubator.
TM
unit into the bottom of the reservoir.
TM TM
cable to Humisonic adapter. Connect adapter to the control panel.
TM
Humisonic
reservoir
TM
humidifier units designed for on – off use. Leaving the unit on for prolonged periods of time will decrease
TM
reservoir
Float valve
1-2 cm
level sensor
TM
Humisonic unit
12
Reservoir
4 lt (1 Gallon)
Flexible hose
Humisonic
cable
Cover Air-in hole
TM
reservoir cover.
TM
Humisonic
Adapter
TM