Bluetooth Function - Teac MC-D800 Manual Del Usuario

Bluetooth function

Pairing fails.
e Refer to the Bluetooth device's operation manual .
e Put this unit into standby and turn the other
Bluetooth device off and on once . Then, try pairing
again .
e Turn off all Bluetooth devices other than the one
you are trying to pair the unit with .
e After deleting the "MC-D800" data from the other
Bluetooth device, try pairing again .
Cannot connect.
e Confirm that the other Bluetooth device is on and
its Bluetooth function is enabled .
e Are the unit and the other Bluetooth device too far
apart? Is there a wall or other obstruction between
them?
As much as possible, use them close together in an
environment without obstructions .
e Put the unit into standby and then on again .
e Unpair the "MC-D800" from the Bluetooth device
and follow the instructions in "Pairing with another
Bluetooth device" on page 44 .
The touch pairing reader does not work.
e Press the CD/Bluetooth/USB button to select
"Bluetooth" .
e Check the settings of the other device that you are
using .
The sound skips or there is noise.
e Is there a wireless LAN, other Bluetooth device,
microwave oven or similar electronic equipment
nearby?
Keep such devices as far away as possible .
e Reduce the distance between the other Bluetooth
device and this unit during use .
e Try moving the other Bluetooth device and this
unit .
62
Troubleshooting (continued)
Radio
A station cannot be received. The reception is
poor.
e Tune in the station properly .
e If FM broadcast reception is poor, try relocating the
FM antenna .
e If AM broadcast reception is poor, try changing the
orientation of the AM antenna .
e Confirm that the FM antenna cable has been con-
nected correctly .
e If a TV is near the unit, turn the TV off .
FM stereo broadcasts become mono.
e Press the FM MODE button to select stereo .
e The signal from the station might be poor . Adjust
the position of the FM antenna and check whether
the FM antenna cable has been connected correctly .
Records
It will not play a record. Playback is noisy.
e Confirm that the stylus cover (made of white plas-
tic) has been removed .
e Clean the stylus (page 17) .
e If the stylus is worn-out, replace it .
The pitch is wrong.
e Set the rotation speed (RPM) to match the record
(page 46) .
The sound skips.
e Vibrations will cause skipping . Place this unit in a
stable location .
e If the record is dirty, wipe it clean .
e Do not use scratched records .
e Use a coin or other tool to turn the transport lock-
ing screw clockwise until it stops .
Since this unit uses a microcontroller, external
noise and other interference can cause the unit
to malfunction. If this should occur, unplug the
power cord from the outlet and wait for a min-
ute before plugging the power cord in again and
retrying the operation.