Grinding Coffee Directly Into The Filter Holder; Cleaning; Cleaning The Grinding Mechanism - Graef CM500 Serie Manual De Instrucciones

5. Set the switch to
6. Place the coffee grounds container or coffee filter below the outlet.
9. Press the Start/Stop button.
10. Switch the unit off.

Grinding coffee directly into the filter holder

1. Use the large or the small filter holder retainer as requested.
2. Set requested grinding degree.
3. Hold the group handle into the group handle bracket.
4. Set the switch to
5. Press the group handle against the contact switch. The grinding process will
start automatically.
6. As soon as the filter holder is sufficiently filled, pull it back. The grinding pro-
cess will stop automatically.

Cleaning

Old coffee remaining in the unit may lead to oxidation. This affects the result of the
preparation and an unpleasant and unpalatable taste may develop. The unit should
always be in a well-kept condition in order to ensure a perfect result at all times.
Depending on the frequency of use, clean the unit at least once a week.
Before cleaning, remove the power plug.
1. Use a soft and moist cloth to clean the outer surfaces of the unit. Use a mild
detergent in case of heavy soiling.
2. Close the outlet of the coffee bean container by using the sliding closure. Turn
the coffee bean container anti-clockwise and remove it.
3. Place the unused beans in an airtight container so keep the flavour.
4. Clean the coffee bean container and the coffee grounds container in warm
water using a little washing-up liquid.
5. Afterwards, dry the containers well.

Cleaning the grinding mechanism

•
Remove the power plug.
•
Remove the coffee bean container as described in the chapter titled "Cleaning".
•
Turn the grinding ring to the coarsest degree.
•
Turn the upper grinding mechanism anti-clockwise and remove it.
•
Clean the lower and upper grinding mechanism with the brush enclosed.
•
Place the upper grinding mechanism back in again and turn it clockwise until it
is tight.
•
Place the coffee bean container on the unit again.
•
Turn the grinding ring to the requested grinding degree.
22
.
.