Burnishing With 2550 Model - Tennant 2510 Manual De Operador Y Lista De Repuestos

OPERATION
2. Twist control grips forward to lower pad to floor
and to start pad motor (Figure 11).
FIG. 11
3. Begin burnishing by pushing machine forward.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
4. Adjust pad pressure meter within Green Zone.
Press the pad pressure switch to decrease or
increase pressure. For best results adjust needle
as shown (Figure 12).
GREEN
ZONE
FIG. 12
ATTENTION: Do not operate machine in red zone,
floor damage and brush motor overload may
result.
NOTE: If machine vibrates, realign pad.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
5. To stop burnishing, release grips. The pad will
automatically raise to the transport position.

BURNISHING WITH 2550 MODEL

1. Release parking brake lever, if equipped.
2. Turn on key, if equipped, then turn on main power
and pad switches.
3. Turn speed control knob to slowest speed. This
will prevent an abrupt take off (Figure 13).
10
Meter Needle
RED
ZONE
Home Home Find... Go To.. Find... Go To..
FIG. 13
4. Twist control grips forward to begin burnishing.
Gradually turn speed control knob to desired
cleaning speed (Figure 14).
FIG. 14
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
5. Adjust pad pressure meter within Green Zone.
Press the pad pressure switch to decrease or
increase pressure. For best results adjust needle
as shown (Figure 15).
GREEN
ZONE
FIG. 15
ATTENTION: Do not operate machine in red zone,
floor damage and brush motor overload may
result.
NOTE: If machine vibrates, realign pad.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
6. To operate machine in reverse, simply pull reverse
trigger, one speed (Figure 16).
Meter Needle
RED
ZONE
Tennant 2510/2550 (01- -05)