Installation - Oster OS-DF600S Manual De Instrucciones

I NS TA LLAT IO N
1. This appliance is heavy. Care should be taken when moving it.
2. When you transport the appliance, the angle between the compartment body and the
ground should not be less than 45°.
WARNING: Never put the appliance upside down.
3. Once the appliance has landed properly on a flat and firm surface, remove all the pack-
ing material including any plastic packaging material in the appliance.
4. The back of the appliance should be close to a wall but leaving the required distance
for ventilation.
5. Wash the inside of the appliance with lukewarm water with a little baking soda added
(5ml to 0.5 litre of water). Do not use soap, detergent or any abrasive cleaner to wash, dry
the appliance thoroughly after cleaning.
6. Open the fridge door for ventilation of internal compartments. Idle for 4 hours before
connecting the electrical mains to ensure the refrigerant in the compressor has settled well.
7. Connect the electrical mains and switch in the power for 4 hours initially before adding
any goods. Make sure the surface is solid and will not vibrate when the appliance is op-
erating.
8. If these temperatures are exceeded I,e, colder or warmer, the appliance will not operate
correctly. Should the ambient temperatures be exceeded for long periods, the tempera-
tures in the freezer section will rise above- 18°C and food spoilage may occur.
9. This appliance has to manually defrost and frosting will occur as normal. It is advisable
to manually defrost the appliance when the frosting is at 5mm thick.
English-4