Remote Controls - Cebora POWER TIG 1665 DC HF Manual De Instrucciones

4 REMOTE CONTROLS

The following remote controls may be connected to
adjust the welding current for this welding machine:
Art. 193 Foot control (used in TIG welding)
Art (1268) TIG Torch with potentiometer.
Art (1266) TIG UP/DOWN Torch.
Art 1192+Art 187 (used in MMA welding)
ART. 1180 Connection to simultaneously connect the
torch and the pedal control.
ART. 193 may be used in any TIG welding mode with this
accessory.
Remote controls that include a potentiometer regu-
late the welding current from the minimum to the
maximum current set via the knob O.
Remote controls with UP/DOWN logic regulate the
welding current from the minimum to the maximum.
The remote control settings are always active in the PL
program, while they are not active in a saved program.
13