Hilti DX 76 Manual Del Usuario página 28

If resistance is unusually high when you insert the cartridge strip, check whether the cartridge strip is
compatible with this fastening tool.
Observe the safety instructions and warnings in these operating instructions and on the product.
Safety-related instructions for use
Illustration showing
example
6.1 Loading fastening tool (single-fastener tool)
1. Push the fastener into the fastener guide from the front until the washer of the fastener is held in place in
the fastener guide (1).
2. Push a cartridge strip, narrow end first, into the cartridge barrel (2).
▶ The cartridge strip is fully recessed in the cartridge barrel.
3. Cycle the fastening tool with the cycling grip.
▶ The fastening tool is loaded and ready for use.
6.2 Loading fastening tool (magazine)
1. Insert the strip of ten fasteners into the magazine (1).
2. Push a cartridge strip, narrow end first, into the cartridge barrel (2).
▶ The cartridge strip is fully recessed in the cartridge barrel.
3. Cycle the fastening tool with the cycling grip (3).
▶ The fastening tool is loaded and ready for use.
6.3 Setting driving energy
Select the energy setting that suits the application. If no empirical values are available, always start with the
minimum driving energy. Increase driving energy step by step until the fastener is driven correctly.
For detailed information, request a copy of the Hilti 'Direct Fastening Technology Manual' or the
corresponding local Hilti 'Technical Guide to Fastening Technology' from your Hilti Store.
1. To increase power, turn the adjusting knob for driving energy in the + direction.
Energy levels:
• 1 = lowest energy
• 4 = highest energy
2. To reduce power, turn the adjusting knob for driving energy in the − direction.
3. Check whether the fastener was correctly driven in accordance with the operating instructions of the
fastener.
6.4 Driving fasteners
1. Hold the fastening tool perpendicular to the base material and press the fastening tool against the surface
until it is fully compressed (1).
22 English
Description
Do not press the stud guide or the exposed piston against any part of the
body!
Pressing the fastener guide or the exposed piston against a part of the body (a
hand, for example) can make the fastening tool ready to fire. As a result, there
would be a risk of injury.
Do not pull back the magazine or other fastener guides by hand!
Pulling the magazine back by hand can make the fastening tool ready to fire. As
a result, there would be a risk of injury.
5
6
8
4
282471
*282471*