Cleaning And Maintenance - Royal Catering RC-BMG6650 Manual De Instrucciones

6. Connect the gas line to the ½ BSPT connection. The connection can be rigid,
made with a steel pipe, or flexible, made with an elastic gas tube (the length of the
elastic tube must not exceed 150 cm).
7. Remove all protective films before use.
8. After making the connection, check its tightness with a special spray or soapy
water.
3.3. Device use
Filling and emptying the tank
Before starting work, pour water into the tank. Remember not to exceed the maximum
level marked inside the tank. Place the containers in the tanks. The containers can be
inserted with warm food or empty - the food can be added after they are placed in the
tanks. After finishing work, turn off the device, wait for it to cool down, then remove
the containers, wash and dry them, pour out the water from the tanks and dry it.
Starting the burner
1. Press the temperature control knob and turn it clockwise to the "
2. Hold the knob in this position and press the red ignition button with the other hand
until you hear a distinctive sound (click).
3. Observe through the openings in the burner shield that the burner has ignited. If it
does not ignite within 10 seconds, stop igniting, turn the knob to the "
wait 10 minutes. After this time, try again.
Note! The ignition time will be considerably longer when using the device for the first
time or after it has not been used for a long time.
4. When the flame ignites, keep the knob in the "
then slowly release it.
5. If, after releasing the knob, the flame disappears, turn the knob back to the "
position and wait 5 minutes, then repeat steps 1-4.
6. The fire will be at its maximum intensity when the knob is turned to the "
WARNING! Do not touch hot parts when using the device. The high temperature
may cause burns!

3.4. Cleaning and maintenance

a) Use only non-corrosive cleaners to clean the surface.
b) Use only mild, food-safe detergents to wash the device.
c) After cleaning the device, all parts should be dried completely before using it
again.
" position for another 7-10 seconds,
" position.
" position and
"
" position.