Garmin Tread Instrucciones De Instalación página 3

Attaching the Power Cables to the Mount
1 Thread the power cable connector
2 Pull the cable back until it is snug.
3 Screw the black screw
NOTE: An additional replacement screw is included in the box.
Attaching the Base Plate to the Mount
Direct, sustained contact with the base plate, or any other part of the vehicle, may damage the mount over time.
To prevent this kind of damage, you must place the mounting spacers between the mount and base plate, and
make sure that no part of the device or mount touches the vehicle.
1 Thread the M4 x 20 mm panhead screws
base plate .
2 Tighten the nuts to secure the base plate.
Installation Instructions
through the opening
into the back of the mount
NOTICE
through the washers
in the mount.
to hold the cable in place.
, cradle, bushings, spacers , and
3