Low Flame Adjustment; Adjustment For Burners With One Or Two Flame Rings; Adjustment For Lower Oven Burner (Necessary Only For Models With Thermostatic Valve) - Fulgor Milano SOFIA PRO-RANGE F6PGR366S2 Instrucciones Para La Instalación

Low Flame Adjustment

DANGER
Lighting gas burners with a match is dangerous.
You should match light the burners only in an emergency.
Light a match and hold the flame near the burner you want
to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the burner you
are lighting.
NOTE: If the burner does not light within five seconds, turn the
knob off and wait one minute before trying again.
CAUTION
If you attempt to measure the inner cone of the flame, please
use caution.
Burns could result.
This appliance is shipped from the factory with low and
medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one or two flame
rings:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Remove knob seat from control panel.

ADJUSTMENT FOR LOWER OVEN BURNER (NECESSARY ONLY FOR MODELS WITH THERMOSTATIC VALVE)

6 - Conversion for LP or NG Gas
4. Insert a slender, thin-blade screwdriver into the recess
behind the control knob (A or B) and engage blade with
slot in adjusting screw.
5. Turn adjusting screw to set flame size:
• clockwise to reduce
• counterclockwise to increase
6. Replace control knob when adjustment is completed.
Adjustment for Lower Oven Burner (necessary
only for models with Thermostatic Valve):
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
Conversion from natural gas to liquid gas
3. insert the screwdriver in the hole in the front wall of the
instrument panel and turn regulation screw A clockwise.
Conversion from liquid gas to natural gas
4. Light the oven with thermostat set to 250 °C for at least 10-
15 minutes.
Then, turn the thermostat to the minimum position and turn the
bypass screw A counterclockwise until you see a reduced by
stable flame.
NOTE: Check that the flame does not go out when the door of the
5. Replace control knob when adjustment is completed.
ADJUSTMENT FOR COOKTOP BURNERS
oven is opened and closed repeatedly. If the flame goes
out, slight increase the minimum regulation setting.
EN
A SIMMER
B MAIN FLAME
21