Paragraph 6 – Weekly timer
It is possible to program 10 dosages for the whole week. Press
the dosages.
1) The program number can be modified using the
2) The dosage time can be modified using the
3) The dosage quantity can be set in "ml" using the
The dosage time, that is to say the time in hours, minutes and seconds during which you wish to dose the set
quantity, using the
in the programmed time, it will dose as long as it does not end the dosing quantity.
4) The values of the relay connected to dosage can be modified using the
key; in "Off" mode, does not change state and remains open, and in "after" mode the relay
pressing the
reopens after finishing the dose and after being spent the time (in seconds) set using the
confirmed by pressing the
seconds) set using the
5) Day activation, or rather the days on which you want the set program to be active (start time, quantity, dosage
duration and relay operating mode). Press the
activate/deactivate dosage and the
automatically to the next program.
Repeat the whole procedure if you need to program the new program, or press
The next step in the main menu is programming the clock. This can be done by pressing the
using the
to set the required values and then confirming by pressing the
hour and minutes in sequence. Obviously, the set time and day are those that the programming will refer to.
ATTENTION: If you activate a programmed dose is not possible to stop it except by the power failure. Any change
takes place in the programming time will have affection only for the next dose.
EM00136592
keys and confirmed by pressing the
key. In "before" mode, the relay will open only after the dosage set, for the time (in
keys and then confirmed by pressing the
key to change the day of the week. Press
rev. 1.0
in the "weekly timer" mode in order to program
keys and confirmed by pressing the
keys and confirmed by pressing the
keys and confirmed by pressing the
key. If the pump does not stop the dosage
key.
key to make changes, then press the
EN
key.
key.
key.
keys and confirmed by
keys and then
key to
to confirm and move
to return to the main menu.
to make changes,
key. You can set the day,
9