Setting The Language - Astral ACQUA DOS Manual De Instalación

Setting the Language

Programming
Paragraph 1 – Manual Dosage
Programming
Display during Operation
Operating mode
• MAN = Manual
MAN
Lev
Alarms and statuses
• Lev = Level alarm
• Empty = pump in start
• Stop = pump stationary
• Pause = pump in pause
Paragraph 2 - Dosage Proportional to Signal 0/4-20
Programming
EM00136592
Makes it possible to select the language. The pump is set in English in
the factory.
Changes can be made by pressing the
the main menu
The pump operates in constant mode. The flow can only be manually
regulated by pressing the
the flow, or the
Current dosage speed
(depends on selected unit of
measurement)
• Percentage, Frequency
Stop P100%
Pump status
The pump proportionally doses at a signal of (0)4-20 mA. On the basis of
the factory settings, the pump interrupts dosage at 4mA and doses at the
maximum set frequency when it receives 20 mA. These two values can
be modified during programming. The maximum frequency can be
modified during operation, by pressing the
time to increase the flow, or the
For an input signal below 0.2 mA, the alarm LED lights up to indicate the
absence of a signal.
rev. 1.0
Operation
keys to set the new value. Press
Operation
keys to decrease it.
Display during Setting (MODE key)
Operation
EN
key, then using the
to confirm and return to
keys at the same time to increase
keys at the same
keys to decrease it.
6