Uline H-9442 Manual Del Usuario página 2

3. Repeat steps 1 and 2 for opposite side. Tighten all
bolts fully on both sides using 11/16" wrench.
(See Figure 3)
Figure 3
4. Place one wood step over the metal step frame and
align four holes. Attach through pre-drilled holes
using four M6 x 58 mm bolts with M6 nuts and lock
washers by hand. Repeat for remaining step. Tighten
all bolts fully using 13/32" wrench.
(See Figures 4a-4b)
Figure 4a
5. Insert ganging posts into open holes on brackets on
back end of steps. For 16" H platforms, use shorter
ganging posts. For 24" H platforms, use longer
ganging posts. (See Figure 5)
Figure 5
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
Figure 4b
1-800-295-5510
TO ATTACH STEPS TO STAGE:
1. Place steps next to desired location adjacent to the
stage. (See Figures 6a-6b)
Figure 6a
NOTE: Figure 6a shows attachment to 16"
H platform. Figure 6b shows attachment to
24" H platform.
2. Raise one ganging post up until connector bracket
comes in contact with stage apron. (See Figure 7)
Figure 7
3. Use knob to secure connector bracket to back of
stage apron.
4. Repeat Steps 2 and 3 for other ganging post.
uline.com
Figure 6b
0421 IH-9442