Connecting Active Current Source - Endress+Hauser RIA 261 Manual De Instrucciones

5 Electrical connection
#
36
The electronic component can be hinged forwards for simple
installation and easy cable laying.
ƒig. 4: Electrical connection
In order to do this follow these instructions:
•
Loosen and remove the unit lid.
•
Hold the top of the electronics and pull forwards and down,
(see sketch).

5.1.3 Connecting active current source

E.g. a sensor with its own power supply and active current
output:
Note: If a respective barrier is used the unit can be installed
directly in the hazardous area.
ƒig. 5: Connecting active current source
Digital field display