Skil 7338 Manual Original página 5

Orbital sander
INTRODUCTION
This tool is not intended for professional use
Read and save this instruction manual 3
TECHNICAL DATA 1
TOOL ELEMENTS 2
A
B Connection for vacuum cleaner
C Ventilation slots
SAFETY
GENERAL SAFETY INSTRUCTIONS
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and instructions
all warnings and instructions for future reference. The
term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
1) WORK AREA SAFETY
a) Keep work area clean and well lit. Cluttered or dark
b) Do not operate power tools in explosive
liquids, gases or dust. Power tools create sparks
c) Keep children and bystanders away while operating
a power tool. Distractions can cause you to lose
2) ELECTRICAL SAFETY
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools.
b) Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of electric
f) If operating a power tool in a damp location is
unavoidable, use an earth leakage circuit breaker.
Use of an earth leakage circuit breaker reduces the risk
7338
3) PERSONAL SAFETY
a) Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
moment of inattention while operating power tools may
b) Use personal protective equipment. Always wear
eye protection. Protective equipment such as dust
mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will reduce
c) Prevent unintentional starting. Ensure the switch
source and/or battery pack, picking up or carrying
the tool.
switch or energising power tools that have the switch on
d) Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to
a rotating part of the power tool may result in personal
Save
e) Do not overreach. Keep proper footing and balance
at all times. This enables better control of the power
f) Dress properly. Do not wear loose clothing or
jewelry. Keep your hair, clothing and gloves away
from moving parts.
g) If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used. Use of dust collection
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use the correct power
tool for your application. The correct power tool will
b) Do not use the power tool if the switch does not
controlled with the switch is dangerous and must be
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
5
Any power tool that cannot be
A