EGAmaster 65512 Manual De Instrucciones página 10

7. To turn the level, press the I/0 key.
VERTICAL OPERATION
No accessories are needed for this position. The level can be used directly on the ground.
However, it can be used on the wall mount for a better setup.
1. Place the unit in vertical position, resting on the support point, use the adjustable feet to
rough level the laser by the bubble vial.
2. Turn on the I/O key for short time.
3. Automatic self-leveling function working and levelling begins automatically. When levelling
is completed, the rotor begins to rotate and emits visible laser beam.
4. In vertical automatic mode, the rotor can be moved along the right and left direction by
pressing slope key. The unit will be auto self-leveled continually while operating this step.
5. After self-leveling, the operation is same as the operation.
6. After turn on the unit, press and hold the I/O key for more than 3 seconds, it will enter
manual mode. The operation is same as the operation.
Note:
•
Before operating the instrument, perform the check and adjustment of the datum point.
•
In the manual mode, please be noted that the horizontal accuracy of emitted laser beam
is not guaranteed.
•
When speed selection is at 0rpm the scan function shall be available, or the scan
function will not be activated.
•
After turn on the unit, the unit will give off alarm if it is out of the compensating range,
and 10 seconds later, the unit power supply will be automatically shut off automatically
and the unit will be in "Sleep" state. Because level is a instrument with high precision, it
is preferable to use remote controller to perform functions.
•
While performing various functions, the corresponding indications will be interpreted by
LEDs.
All manuals and user guides at all-guides.com