Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
When the unit is in horizontal automatic mode, the slope function will not be available.
•
While the unit is not in service, make sure to switch it off.
•
Make sure to switch off the power to shift horizontal operation of the unit to vertical
operation. It applies to the other way around.
Warning: while the instrument is in operation, be careful not to expose yours ayes to the
emitting laser beam (red light source). Exposure to a laser beam for a long time may be
hazardous to your eyes.
POWER OPERATION
1. Before first-time use, the rechargeable batteries must be recharged for 4 hours by a special
charger.
2. Insert the charger plug into the jack located on the battery pack.
3. Plug the charger into an electrical outlet (110volts or 220volts, depending on charger and
country)
4. After charge for 4 hours, the LED on the charger will be charged the colour.
5. When the battery's power is low, remove the battery pack from the unit and charge it.
6. For optimum life of the battery, it is recommended to charge the battery after fully
discharged. To assure battery life, do not charge over 10 hours.
7. The battery and the charger can be damaged if damp. Always store and charge the unit in a
dry and covered place.
OPERATING THE DETECTOR
Detector mode
1.Bubble vial
2.LDC Display
3.Capture window
4.ON/OFF
5.Coarse/Fine
6.Sound switch (high, low mute)
7.Illumination
All manuals and user guides at all-guides.com
LCD Display
1.Indication of sound level
2.Lower the detector
3.Level
4.Raise the detector
5.Battery level
6.Coarse/Fine mode
Publicidad
Tabla de contenido
