Uline H-2080 Manual Del Usuario página 2

ASSEMBLE SHELVING UNIT
1. Start with the lowest shelf. Snap the interlocking
pieces of a shelf support (wide end down) around
the post at the lowest groove where shelf is to be
located. (See Figure 2)
Figure 2
NOTE: The bottom shelf supports should be
located on the first groove from the bottom.
2. Slide the support up or down until it snaps into the
groove. Add a shelf support to the same place on
the remaining posts.
3. Slide posts through underside of shelf until shelf
slides firmly over supports. (See Figure 3)
Figure 3
4. Stand unit upright. Gently tap shelf down to secure it.
(See Figure 4)
Figure 4
PAGE 2 OF 6
ASSEMBLY CONTINUED
5. Determine the height of the handle, and snap on
supports. Gently tap down handle to secure.
(See Figure 5)
Figure 5
6. Determine the height of the second shelf, snap on
supports and secure shelf.
INSTALL CARTON DIVIDERS
1. Position Carton Dividers along each shelf, spaced
as desired.
2. Attach Carton Dividers using Carton Divider Brackets
beneath the shelf using bolts, lock-washers and nuts.
(See Figure 6)
Figure 6
1-800-295-5510
uline.com
0221 IH-2080