Holmatro BCU 05 A Serie Manual página 45

7.5 The deadman's handle is jammed or doesn't return automatically to the
neutral position
/i
Possible cause
The deadman's handle is damaged
externally.
The deadman's handle is faulty.
7.6 The light is weak or gives no light at all
/i
Possible cause
The battery is (almost) empty.
7.7 The cutting is poor
/i
Possible cause
The blades are damaged.
The tightening torque of the centre bolt is
incorrect.
8 Maintenance
8.1 General
Proper preventive maintenance of the equipment preserves the operational safety and extends the life
of the equipment. For malfunctions or repair, always specify the model and serial number of the
equipment.
CAUTION
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
8.2 Dangerous substances
CAUTION
Used or leaked fluids, and any other products consumed during the activities,
must be collected and disposed of in an environmentally responsible way.
8.3 Maintenance materials
/i
Application
Steel parts
Hinge pins
Long-term preservation
Contact the Holmatro dealer for information on spare parts.
BCU * A *
All manuals and user guides at all-guides.com
Type of maintenance material
WD-40 preservative oil
Teflon lubricating oil
Tectyl ML from Valvoline
916.400.018_003
Solution
Have it repaired by a Holmatro Certified Technician.
Have it repaired by a Holmatro Certified Technician.
Solution
Replace the battery.
Solution
Sharpen or file the cutting edge of the blades in the
correct shape.
Tighten the bolt to 50 Nm.
EN
Amount
As required
As required
As required
45