Care And Cleaning - Homewerks 55-K821S-SS-T Instrucciones De Instalación

INSTALLATION INSTRUCTIONS (Continued)
9.
From underneath the sink, screw the plastic
soap bottle (9.1) onto the soap dispenser
shank (9.2).
ASSEMBLING THE FAUCET WITHOUT THE HANDS-FREE FEATURE
1.
Disconnect the control box (H). Attach the
black spray hose (1.1) to the shortest
braided line (1.2) coming from the
faucet body (A).
OPERATING INSTRUCTIONS
The lever handle controls the flow of hot and cold water to the faucet. Rotate the handle out and forward for cold water. Rotate the handle out and backward for
hot water. Moving the handle outward opens the cartridge and causes water to flow from the spout. The degree of handle opening determines the volume of
water flow. Returning the handle to the original position toward the faucet body stops the flow of water.
USING THE HANDS-FREE FEATURE
To use the touchless feature, turn on the water and adjust to the desired temperature. Wave your hand next to the sensor to turn off the water.
To turn the water back on, wave your hand next to the sensor again. If left running, the water will automatically shut off after three minutes to conserve water.
Returning the handle to the original position toward the faucet body will deactivate the hands-free sensor. The lever handle must be placed in the on position
to activate the touchless feature.
When the battery level is low, a red light will appear in the sensor area to indicate it is time to replace the batteries.

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
HomewerksWW.com
9
9.2
9.1
1
1.2
1.1
H
10 .
Once the installation is complete, remove
the sprayhead (10.1) from the spout (10.2)
on the faucet body (A) to flush the water
lines. Turn on the water supply and allow
both hot and cold water to run for at least
one minute to flush away any debris that
could cause damage to internal parts. While
the water is running, check for leaks. If leaks
occur, gently tighten the nut on the
connection that is leaking. Turn off the water
and screw the sprayhead (10.1) back onto
the spout (10.2) of the faucet body (A).
3
10
10.2
A
10.1