Tire Pressure - Cub Cadet RT 45 Manual Del Operador

3. Slide the emergency stop
control switch wire through the
opening on the bottom right side
of the handle panel, where clutch
cables were previously routed.
See Figure 5.
4. Route the emergency stop control
wire behind the handle, then to the
left side of the handlebar. Secure
with a cable tie immediately after
routing out from behind the panel.
See Figure 6.
5. Mount the emergency stop
control ON/OFF switch onto the
left side of the handlebar with the #10-32 : 1.50 hex bolt and 10-32 flange
lock nut. See 1 in Figure 7.
6. Finally, secure the wire near the bottom of the handlebar with a cable tie
looped through the hole beside the instruction label on the left handlebar.
See 2 in Figure 7.
Figure 6
Move Tiller Off Crate
To roll the tiller off the shipping platform, put the wheels in FREEWHEEL, if they are
not already from the factory, as follows:
1. Place a sturdy block under
the transmission to raise
one wheel about 1" off
the ground. Remove the
click pin from the wheel
hub and wheel shaft. See
Figure 8.
2. Slide the wheel fully inward
on the wheel shaft. Reinstall
the click pin through the
wheel shaft only (not
through the wheel hub).
See Figure 8. The wheel
should now spin freely
(FREEWHEEL) on the wheel shaft. Repeat with the other wheel.
3. Use the handlebar to roll the tiller to a flat area.
NOTE: Before starting the engine, the wheels must be placed in the WHEEL DRIVE
position (pins through wheel hubs and wheel shaft).
4. Once the tiller is off the crate, place the wheels in the WHEEL DRIVE position.
Remove the click pin, slide the wheel outward until the hole on the wheel
hub aligns with the hole on the drive shaft and reinstall the click pin.
ASSEMBLY & SET-UP
Figure 5
1
2
Figure 7
Click Pin
Slide the wheel fully
Remove the
inward on the wheel
click pin from
shaft. Reinstall the
the wheel hub
click pin
Figure 8
Set-Up

Tire Pressure

Check the air pressure with a tire gauge. Deflate or inflate the tires equally to
between 15 and 20 w. DO NOT EXCEED 20 P.S.I.
NOTE: Be sure that both tires are inflated equally or the tiller will pull to one side.
Gas & Oil Fill Up
Use extreme care when handling gasoline. Gasoline is extremely flammable
and the vapors are explosive. Never fuel the machine indoors or while the
engine is hot or running. Extinguish cigarettes, cigars, pipes and any other
sources of ignition.
Service the engine with gasoline and oil as instructed in the Engine Operator's
Manual packed separately with your tiller. Read the instructions carefully.
6
WARNING