Operation - PowerSmith DB2801RB Manual Del Usuario

Step 2: Installing The Chute Assembly
1. Insert chute and chute handle to the base. (See Fig. 2).
2. Using 13mm wrench secure chute to base with (2) Screws, washers and nuts provided.
Note: Do not over-tighten the lock nuts.

OPERATION

WARNING: Do not allow familiarity with this product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict serious injury.
WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1.
Failure to do so could result in objects being thrown into your eyes and other possible serious
injuries.
WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this
product. The use of attachments or accessories not recommended can result in serious personal injury.
To Install Battery Pack
When not in use, battery pack should be stored in an enclosed area where the temperature will not drop
below -4°F (-20°C). Optimal charging temperatures are between 32°F (0°C) and 122°F (0°C - 50°C).
WARNING: If any parts are broken or missing, do not attempt to attach the battery pack to the
snow blower or operate the snow blower until the broken or missing parts are replaced. Failure to
do so could result in serious injury.
1. Open the battery compartment cover and slide the battery vertical down as Fig 3 shows.
2. Insert the safety key into the slot and close the battery compartment cover as Fig 4 shows.
Fig.3 Fig.4
11