Maintenance And Storage - PowerSmith DB2801RB Manual Del Usuario

• Never operate the snow blower without good visibility or light. Always be sure of your footing,
and keep a firm hold on the handles. Walk; never run.
• Use only with the battery pack and chargers listed below:
BATTERY PACK
DB2108
CLEARING A CLOGGING DISCHARGE CHUTE
Hand contact with the rotating auger assembly inside the discharge chute is the most common cause
of injury associated with snow blowers. Never use your hand to clean out the discharge chute.
To clear the chute:
• SHUT THE MOTOR OFF!
• Wait 10 seconds to be sure the auger assembly blades have stopping rotating.
• Always use a clean-out tool, DO NOT use your hands.

MAINTENANCE AND STORAGE

• Check all bolts or fasteners at frequent intervals for proper tightness to be sure the equipment is in
safe working condition.
• Always refer to operator's manual for important details if the snow blower is to be stored for an
extended period.
• Maintain or replace safety and instruction labels, as necessary.
• Run the machine a few minutes after blowing snow to prevent freeze-up of the auger assembly.
•
Optimal charging temperatures are between 32°F (0°C) and 122°F (0°C - 50°C).
SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who
may use this tool. If you lend this tool to someone else, also lend these instructions to them to prevent
misuse of the product and possibly injury.
CHARGER
DB2208
8