PowerSmith DB2801RB Manual Del Usuario página 13

Adjusting the Chute
The chute can be adjusted to change both the direction and the distance of the discharged snow to
assist you in moving snow away from one area and placing it in another.
The throwing distance of the snow blower is adjusted by moving the chute deflector up or down.
Loosen the knobs to raise or lower the deflector to the desired degree of snow you wish to throw.
Tighten the knobs to secure the deflector. (Fig.7)
Deflector knobs
Fig.7
The direction of snow removal can be adjusted up to 180°.
You can adjust chute direction by rotating the chute handle in panel. (Fig.8)
Chute Control handle
Fig.8
WARNING: Do not force the chute so far forward that a gap appears between the deflector and
the chute itself. Snow or other debris could be thrown through the gap and back at the operator,
resulting in serious personal injury.
WARNING: Do not adjust the chute deflector while the auger control switch is engaged. Always
release the auger control switch before adjusting the chute deflector.
To Clear the Chute
1. Turn the motor and auger off!
2. Remove the battery pack from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use a clean-out tool, such as a wood rod or other clearing tools that are commercially
available; do not use your hand.
13