brennenstuhl Secure-Tec Automatic 19.500 A Instrucciones De Uso página 16

065612 Secure-Tec Automatic_065612 Secure-Tec Automatic 1 1
Operating Instructions
This will be recognized by the extension socket,
too, and the slave sockets will be switched off
completely within a certain delay.
Naturally, also combinations of TV, radio, receiver
etc. are controllable.
The power consumption of the master device
must be >8 W in the energized condition and in the
de-energized condition (standby operation) it must
be <80 W.
The switching status of the slave sockets will be
shown by the control light "Slaves on".
If necessary, a threshold level switch can be used
with this model to select the appropriate switching
threshold (i.e. decide whether to switch slave
sockets on or off).
Adjusting the Threshold Level Switch
To adjust the threshold level switch, use a small
slot screwdriver and proceed as follows:
1. Plug your master device into the master socket,
switch the device on and wait until it is on (e.g.,
boot up your PC).
2. If the "Slaves on" control lamp does not stay lit
as a result, turn the threshold level switch
slowly and carefully until it stays lit.
3. Switch your master device off again and wait
until it is completely off. Do not unplug it from
the master socket (e.g., power down your PC to
standby mode).
16
Secure-Tec