Operating The Engine; Starting The Engine; Adjusting The Carburetor - MADER KM0403580M Manual De Instrucciones

Tabla de contenido

Publicidad

5.Operating the engine

It is very dangerous to run a chainsaw that mounts broken
parts or lacks any parts.
Before starting engine,make sure that all the parts
including bar and chain are installed properly.

█STARTING THE ENGINE

1.
Fill fuel and chain oil tanks respectively, and tighten the
caps securely.
2.
Set the switch to "I" position.
3.
Pull out the choke knob to the second-stage position.The
choke will close and the throttle lever will then be set in the
starting position.
choke knob
Note: When restarting immediately affer shopping the
engine,set the choke knob in the first-stage position(choke
open and throttle lever in the starting position).
Note: Once the choke knob has been pulled out,it will not
return to the operating position even if you press down on it
with your finger.When you wish to return the choke to the
operating position,pull out the throtte lever instead
4.While holding the saw unit securely on the ground,
pull the starter rope vigorously.
Do not start the engine while the chain saw hangs in
one hand.The saw chain may touch your body.This
in very dangerous
5.When engine has ignited,first push in the
to the first-stage position and then pulthe starter again to
start the engine.
6. Allow the engine to warm up with the throtte
lever pulled slightly.
▉CHECKING THE OIL SUPPLY
After starting the engine, run the chain at mendium
speed and see if chain oil is scattered off as shown
in the figure.
Chain oil

ADJUSTING THE CARBURETOR

The carburetor on your unit has been factory
adjusted, but may require fine tuning due to a
change in operating conditions.
Before adjusting the carburetor, make sure that the provided
air/fuel filters are clean and fresh and the fuel properly
mixed.
When adjusting, take the following steps:
.
Note: Be sure to adjust the carburetor with the bar chain
attached.
1.Stop engine and screw in both the H and L needles
until they stop.Never force them.Then set them back the
initial number of turns as shown below.
2.Start the engine and allow it to warm up at
3.Turn the L needle slowly clockwise to find a
where idling speed is maximum, then set the needleback a
quarter (1/4) turn counterclockwise.
4.Turn the idle adjusting screw (T) counterclockwise so that
the saw chain does not turn. If the idling speed istoo slow,
turn the screw clockwise.
5. Make a test cut and adjust the H needle for best cutting
power, not for maximum speed.
Keep clear of the saw chain as it will start rotatubg
upon starting of engine.
Make sure to set up the bar and the chain when
checking the oil supply.
.
If not, the rotating parts may be exposed.It is very
dangerous
H needle: 3/4 ±3/8
L needle: 11/2 ±1/4
choke knob
half-throttle.
position

Publicidad

Tabla de contenido
loading

Tabla de contenido