Maintenance - MADER KM0403580M Manual De Instrucciones

Tabla de contenido

Publicidad

A log lying on the ground
Saw down halfway ,then roll the log over and cut from
the opposite side .
A log hanging off the ground
In area A.saw up from the bottom one-third and finish
by sawing down from the top .In area B,saw down from the top
one-third and finish by sawing up from the bottom.
Cutting the limbs of Fallen Tree

7.Maintenance

Before cleaning,the inspecting or repairing the
unit,make sure that engine has stopped and is
cool .Disconnect the spark plug to prevent
accidental Starting.
MAINTENANCE AFTER EACH USE
1.
Air filter
Dust on the cleaner surface can be removed by tapping a corner
of the cleaner against a hard surface.To clean dirt in the
meshes ,split the cleaner into halves and brush in gasoline.
When using compressed air.blow from the inside .
To assemble the cleaner halves,press the rim until it clicks.
No Note:When installing the main filter ,make sure that the
grooves on the filter edge are correctly fit with the projections on
the cylinder cover.
2.
Oiling port
Dismount the guide bar and check the oiling port for clogging
First check to which side the limb is bent .Then make the
initial cut from the bent side and finish by sawing from the
opposite side.
Be alert to the springing back of a cut limb
Cut up from the bottom ,finish down from the top.
Do not use an unstable foothold or ladder.
Do not overreach.
Do not cut above shoulder height.
Always use both your hands to hold the saw.
3.Guide bar
When the guide bar is dismounted,remove sawdust in the
bar groove and the oiling port.
Grease the nose sprocket from the feeding port on the tip
of the bar.
4.Others
Check for fuel leakage and loose fastenings and damage to
major parts,especially handle joints and guide bar
mounting.If any defects are found ,make sure to have them
repaired before operating the saw again.
PERIODICAL SERVICE POINTS
1.
Cylinder fins
Dust clogging between the cylinder fins will cause
overheating of the engine .Periodically check and clean the
cylinder fins after removing the air cleane r and the cylinder
.
cover , make sure that switch wires and grommets are
positioned correctly in place.
Note:Be sure to block the air intake hole.
.

Publicidad

Tabla de contenido
loading

Tabla de contenido