Starting + Stopping - SNOWJOE SUNJOE 24V-MDTCR1-CT Manual Del Operador

Target category bar
Iron Gold
range range
Target-ID icons
Icon
ferrous metals
Aluminum and
other alloys
Gold and bronze
Zinc and copper
(some gold and bronze)
Silver and copper
Silver and copper
Silver and copper
NOTE: Due to a variety of environmental factors the induced
electromagnetic field of metallic objects may vary greatly
affecting the accuracy of the readings. These include but are
not limited to:
• Soil depth
• Ground minerals
• Soil composition
• Object size and angle
• Object oxidation and purity
• Object surface texture
• Electromagnetic Interference
B. Sensitivity Level Indicator – Indicates the detection
sensitivity. The more bars, the higher the sensitivity.
C. Battery Level Indicator – Indicate remaining battery
power. Refer to the table below for the battery percentage
for each interface.
25% 50%
Silver
range
Metals US Coin
Iron and
Nickel
(5 cents)
Penny
(1 cent)
Dime
(10 cent)
Quarter
(25 cents)
Half dollar
(50 cents)
75% 100%
NOTE: The battery must be recharged when the power
drops to 25% or less.
D. Pinpoint Indicator – Indicates the metal detector is in
pinpoint detection mode.
E. Setting Button – Configures sensitivity, discrimination
and volume.
F. DISC Button – Filters out one or more target-IDs from
your detection readings. It can also turn on the LCD
backlight for use in the dark.
G. Pinpoint Button – Enters the pinpoint mode.
H. Power Button – Turns the device ON/OFF.
I. Enter Button – Confirms the adjustment of each setting.
J. Adjustment Buttons – Changes sensitivity, discrimination
and volume settings up or down.
K. Volume Adjustment Indicator – Flashes to indicate
volume setting mode.
L. Depth Indicator – Shows the relative depth of the buried
target. The more bars shown, the further the coil is from
the target.
M. DISC Bar – Shows frames that are crossed off, to
indicate that those target-IDs have been filtered out from
the metal detector's readings.
Tones
The metal detector emits three audible tones to identify the
metal being detected. See the table below for details.
Iron
Low Tone
It's recommended to test the metal detector and get familiar
with each tone before operation.

Starting + Stopping

1. Insert the battery in the battery compartment until it clicks
into place (Fig. 13).
Fig. 13
Battery pack
11
Gold Silver
Mid Tone High Tone