SNOWJOE SUNJOE 24V-MDTCR1-CT Manual Del Operador página 12

2. Press the power button to turn on the metal detector. The
detector will beep three times and the LCD will illuminate
in standby mode (Fig. 14).
3. To turn off the device, press the power button again.
Remove the battery before storing it away.
Sensitivity Adjustment (Fig. 15)
Sensitivity
level
indicator
Setting
button
x1
1. Press the setting button once to enter the sensitivity
settings mode. The sensitivity level indicator will start
flashing.
2. Use the adjustment buttons to set the sensitivity level.
Press to increase the sensitivity, and
the sensitivity.
3. Once you have set the desired sensitivity level, press the
enter button to confirm the change.
NOTE: The metal detector works by inducing a magnetic
field in nearby metallic objects. This magnetic field is then
detected by the search coil and analyzed by the control
panel. However, this magnetic field is also susceptible to
electromagnetic interference produced by other electronic
or environmental sources. EMI can interfere with the
detector and cause it to beep erratically.
Volume Adjustment (Fig. 16)
LCD screen
(standby mode)
Volume
adjustment
Power button
indicator
Fig. 14
1. Press the setting button three times to enter the volume
2. Use the adjusting buttons to adjust the volume. Press
Fig. 15
3. Once you have set the desired volume, press the enter
Increase/
decrease the
sensitivity
Confirm the
change
to decrease
m
near traffic or dangerous area.
12
Lowering the metal detector's sensitivity will help reduce
its susceptibility to EMI. If the metal detector experiences
erratic behavior or false signals, reduce the sensitivity.
Setting
button
x3
setting mode. The volume adjustment indicator will start
flashing.
to increase the volume, and
button to confirm the change.
NOTE: This detector has a 3.5mm headphone jack
located on the bottom of the control panel (Fig. 17).
Allowing use of wired headphones with a 3.5mm plug.
When the headphone jack is connected; speaker volume
is disabled. Headphones can help extend battery life and
reduce noise pollution.
WARNING!
For safety reasons, do not use headphones
Fig. 16
Increase/
decrease
the volume
Confirm the
change
to decrease the volume.
3.5mm
headphone jack
3.5mm
headphone plug
Fig. 17