SNOWJOE SUNJOE 24V-MDTCR1-CT Manual Del Operador página 13

Detection Modes
The metal detector has three detection modes: All Metals,
DISC and Pinpoint.
ALL METALS – All target categories are enabled. Use this
mode to find all metal items. This is on by default.
DISC – Stands for discrimination. Users can filter out one or
more target-IDs from the detection readings (Fig. 18).
Filtered
out
target-ID
Setting
DISC
button
button
x2
1. Press the setting button twice to enter DISC mode. The
first frame should start flashing.
2. Use the adjustment buttons to select the target-ID. Press
to go right, and
3. Press the DISC button, the frame will be crossed off to
show that the target-ID has been filtered out. Do the same
for any other target-ID you do not wish to detect.
4. Once you have configured your DISC mode, press the
enter button to confirm the change.
5. To re-enable a target-ID that has been filtered out, reselect
it using steps 1 & 2 then press the DISC button. The frame
will no longer be crossed off, and detection will resume for
that target-ID.
PINPOINT – Used to pinpoint the location and depth of
buried objects.
1. After locating a possible buried item, press the pinpoint
button. The pinpoint indicator will appear on screen.
2. Slowly move the search coil above the search area using
the audible tones and depth indicator to pinpoint the
location of the buried object.
3. Press the pinpoint button again to disable pinpoint mode.
Metal Detecting
1. Adjust the metal detector as needed. Set your desired
sensitivity, volume and detection mode.
2. Grasp the foam grip on the upper pole and rest your arm
on the arm rest. Use the velcro strap to secure your arm to
the detector. Hold the metal detector with the search coil
parallel with and 1 – 2 inches (2.5 – 5 cm) from the ground
(Fig. 19).
Fig. 18
Select the
target-ID
(left & right)
4
Confirm the
change
to go left.
3. Walk slowly. Sweep the detector side-to-side over the
ground. Keep the search coil parallel to the ground as you
sweep; do not lift the search coil at the end of each sweep
(Fig. 20).
4. Sweep the search coil in a slow arcing motion as shown
below (Fig. 21).
Fig. 21
13
Fig. 19
Armrest
Soft grip
1 – 2 inch
Fig. 20
RIGHT
WRONG