Uline H-3133U-24 Manual Del Usuario

H-3133U-24, H-3134U-24
π
H-3135-24, H-3136-24
H-5210-24
8-12 STEP SAFETY ANGLE
ROLLING LADDERS
24" DEEP TOP STEP
TOOLS NEEDED
Step Ladder
Rubber Mallet
A. Side Handrail (1)
B. Side Handrail (1) Opposite
C. Rear Handrail Bar (2)
(shipped taped to handrail or extension panel)
(2 for 12 step)
D. Stile (1)
E. Base Panel (1)
WARNING! Assembly of these types of ladders
can be inherently dangerous. Please take all
necessary precautions during the assembly
process. Always use a separate ladder to
finish assembly in high places. Never climb a
ladder that is not completely assembled. Do
not assemble or use a ladder with missing or
damaged parts. Use proper lifting mechanics
when assembling a ladder. Watch for overhead
electrical hazards and obstructions.
PAGE 1 OF 9
1-800-295-5510
uline.com
9/16" Wrench or Socket (2)
7/16" Wrench or Socket
Safety Glasses
PARTS
F. Back Panel (1)
G. Horizontal Brace (2)
H. Vertical Brace (2)
ASSEMBLY
STEP 1: FRAME ASSEMBLY
1. Place the ladder stile (D) on the floor. Be sure to
assemble on a protective surface so the finish does
not get damaged. (See Figure 1)
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
J. Handrail Extension Panel (2)
Handrail Bracket (6)
(shipped attached to handrail)
Extension Clamps Set (4)
NOTE: DO NOT tighten bolts until instructed to.
NOTE: Back panel (F) has both round and
slotted holes. The round holes are at the bottom,
and the slotted holes are at the top (L1).
Hardware Kit (1)
(misc. hardware
included)
Notched
Bushing (2 or 4)
Gray Bushing (6)
0521 IH-3133U-24