Uline H-1085U-20 Manual Del Usuario página 3

STEP 5: INSTALL REAR HANDRAIL BARS
1. Detach rear handrail bar (C) from handrail or
extension panel.
2. Insert notched bushing into each end of rear
handrail bars (C). (See Figure 2, Step 5)
3. Position rear handrail bars between mounting holes
on the top part of side handrails using (4) 1/4-20 x 2¾"
hex head cap screws.
NOTE: You may now tighten all handrail bolts.
PAGE 3 OF 9
ASSEMBLY CONTINUED
STEP 6: LEVEL LADDER
1. Stand ladder upright on level surface.
2. Activate safelock by stepping on the trip bar
located in front of the first step.
3. This sets the ladder on the feet to level.
4. When steps are level, tighten all installed bolts.
1-800-295-5510
uline.com
NOTE: DO NOT proceed until ladder is stable.
0521 IH-1084U-20