Mounting Instructions - Audio-Technica ATR7000 Serie Instrucciones De Instalación Y Funcionamiento

english
ATR7000 Series VHF Wireless Systems Installation and Operation
Receiver Controls and Functions
1
POWER
Figure A — Front Panel Controls and Functions
1. POWER INDICATOR: Lights when power is supplied to the receiver.
2. RF INDICATOR: Lights to show presence of transmitter signal.
3. AF PEAK INDICATOR: Only lights when audio distortion is present at
maximum modulation. Not affected by position of Volume control.
4. ON/OFF/VOLUME ROTARY CONTROL: Adjusts the audio level at the ¼"
output jack. Does not affect AF Peak indicator.
5. ANTENNA: Position the antenna as shown in Figure B.
6 7
AUDIO OUT DC IN
Figure C — Rear Panel Controls and Functions
6. AUDIO OUTPUT JACK: ¼" TS (Tip-Sleeve) or "mono" phone jack. Use a shielded cable to
connect to an unbalanced aux-level input of a mixer or amplifier.
7 . POWER INPUT JACK: Connect the DC plug from the included power supply.

Mounting Instructions

The receiver features versatile positioning for horizontal or vertical applications. For a horizontal
application, place the receiver on a horizontal surface (rubber feet on bottom).
For a vertical mounting position, use the included stand mount. The stand mount snaps into
receptacles on the right side of the receiver. Simply insert the stand mount pegs into the
receptacles and slide gently into place until locked. Reverse the motion to remove the stand
mount.
Transmitter Setup Controls and Functions
Battery Selection and Installation
An alkaline 9-volt battery is recommended. Make certain the transmitter power switch is Off
before installing or changing batteries. When inserting the battery, observe correct polarity
as marked inside the battery compartment. The transmitter housings are designed to prevent
incorrect installation of the battery; do not force the battery in. Reversed batteries may cause
damage to the transmitter.
4
2 3
RF PEAK
4
VOLUME
ON OFF
POWER RF PEAK
5
Figure B — Antenna Positions
VOLUME
ON OFF