Shutting Down - SNOWJOE SUNJOE SPX800-PRO Manual Del Operador

1. Remove the foam spray nozzle, and fill the foam cannon
bottle with detergent designed specifically for use with
pressure washers (Fig. 17).
NOTE: Many detergents may require mixing prior to
use. Prepare the cleaning solution as instructed on the
solution bottle.
Fig. 17
Foam
cannon
bottle
2. Recap the foam cannon bottle, and attach it to the trigger
gun. Simply push to lock it onto the Quick-Connect collar
on the end of the lance (Fig. 18).
Fig. 18
Foam
cannon
3. Turn the foam-volume knob on the foam cannon to vary
the amount of foam (Fig. 19).
Fig. 19
Pressure
washer
detergent
Lance
Foam-
volume
knob
4. Turn on the pressure washer. Pull the trigger to operate
the unit. The liquid detergent will automatically mix with
water and be discharged through the nozzle.
5. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
6. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
Rinsing with the Pressure Washer
1. Turn off the pressure washer and shut off the water supply.
2. Pull the trigger to release water pressure.
3. Engage the safety lock on the trigger handle by pushing
down on the safety lock into the slot on the handle
(Fig. 13).
4. Pull back on the quick-connect collar and pull out the
foam cannon to release it.
5. Snap the 25º fan-tip nozzle (green) onto the Quick-
Connect collar until it clicks into place (Fig. 16).
6. Start from the top and work your way down, making sure
to overlap your strokes.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Solvents (e.g. paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.

Shutting down

1. Turn the switch to the OFF/0 position (Fig. 14) and unplug
the power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
10