Carton Contents - SNOWJOE SUNJOE SPX800-PRO Manual Del Operador

Unpacking

Carton Contents

• Electric pressure washer with lower frame assembly
• Upper frame
• Upper frame panel
• Stainless steel lance
• Trigger gun
• High-pressure hose
• Wheels (x2)
• 0º (red) Quick-Connect nozzle
• 25º (green) Quick-Connect nozzle
• Turbo nozzle
• Hardware: washers (x4), cotter pins (x2),
M6 machine screws (x2) and M6 nuts (x2)
• Needle clean-out tool (included with manual packet)
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils, or small
parts. These items can be swallowed and pose a suffocation
risk!
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Assembly
1. Place two washers on either side of the wheel spindle and
insert the wheel axle into the spindle. (Fig. 1).
customer service center at
®
Fig. 1
Wheel axle
2. Fix the wheel by inserting the cotter pin into the hole on
the end of the wheel shaft, as shown (Fig. 2).
Fig. 2
Cotter pin
3. Repeat the above steps for the other wheel.
4. Slide the upper frame into lower frame assembly. They
snap together using springed loaded push buttons and
require no screws (Fig. 3).
Fig. 3
Upper
frame
Lower
frame
assembly
6
Washer Washer
Wheel spindle
Wheel axle