Getting Ready - NEO STEAM 450 INFINITY Manual De Usuario

Description
1. It takes only 30-45 seconds for the first time
heating up. When switched ON the fogging but-
ton of the controller, the unit will start fogging
within 30-45 seconds.
2. It will fog continuously until the liquid is run out.
3. High Safety. No aluminum block inside. So, there
won't be danger of melted heater or firing.
4. When the fog liquid is run out, the pump and the
heater will stop working automatically.

4. GETTING READY

All products are thoroughly tested at the factory
and shipped in perfect condition. If damage has oc-
curred during shipping, or if components are miss-
ing, please contact your local dealer immediately.
Set Up
1. Open the shipping carton and carefully remove
the unit from the shipping carton.
2. Be sure to remove packing material from
around the fog machine, especially near the
nozzle.
3. Set the fog machine on a dry, flat surface.
4. Place the feeder tube with filter deep inside the
full fog fluid tank. Use only high quality, wa-
ter-based fog fluid.
5. Firmly attach the remote control mechanism to
socket on the back of the unit.
6. Plug mains power cord from the fog machine
into appropriate power supply socket. Wait
about few seconds for heating element to heat
up.
7. Refer to your controller manual for operation
details. (Appendix A&B)
8. If fog is emitted continuously for a long time,
the fluid may use out, please keep sufficient fog
fluid in tank.
5. It is equipped with clear LED indicating system:
Lighted red = power; Slow flashing = empty liq-
uid; Fast flashing = Abnormality.
6. Visible fog fluid level indicator on rear.
7. Very compact, light and thin.
8. An easy-to-use design made for convenient oper-
ation in various settings.
9. Operated by line controller (LC-1K) or wireless
controller (RC-1K). Simple and humanized design
makes Steam 450 Infinite easier for use.
Operation
Fogging
Steam 450 Infinite is a fogger that spends very short
time on heating up. Please use LC-1K line controller
for best result.
1. Firmly attach the remote control to socket on
the back of the unit.
2. Plug mains power cord from the fog machine
into appropriate power supply socket. A lit
red LED on the rear indicates that the fogger is
power on.
3. When switched the button of controller to "ON",
it takes only 30~45 seconds for heating up and
start fogging. Switched the button to "OFF" to
stop fogging.
4. When switched the button of controller to
"OFF", Steam 450 Infinite gets into stand-by sta-
tus for 5 minutes. After 5 minutes, the machine
gets cooling down.
5. Refer to your controller manual for operation
details. (Appendix A & B )
Stand by
Every time (cooling down status included) even
switching ON and then OFF the button of the con-
troller immediately, the machine gets in 5-minute
English version - Neo Steam 450 Infinite
P. 5