Getting Ready - NEO STEAM 1500 RGBA Manual De Usuario

Description
1. Built-in function of led lighting control allows
easy control led patterns through by LED display.
Like flames, burst etc. LED could be turn on sep-
arately without fog output under DMX operation
mode.
2. When hanging Steam 1500 RGB upside down,
just loosen the screws of the tank fixed ring and
back board to change the position of the tank.
3. Visible fog fluid level indicator on rear.
4. Special instant stopping function, CO2 effect
alike.
5. DMX on board, 6 DMX modes for choice; 1CH,
2CH, 3CH, 5CH, 7CH & 9CH, operate by any addi-
tional DMX controller.
6. Manual fogging can be operated directly from

4. GETTING READY

All products are thoroughly tested at the factory
and shipped in perfect condition. If damage has oc-
curred during shipping, or if components are miss-
ing, please contact your local dealer immediately.
Mouting
Loosen the few screws of the tank fixed cover,
replace the tank down to the bottom, then put the
tank fix cover to the tank again, and tighten the
screws. See Illustration next page.
Set Up
1. Open the shipping carton and carefully remove
the unit from the shipping carton.
2. Be sure to remove packing material from
around the fog machine, especially near the
nozzle.
3. Set the fog machine on a dry, flat surface.
4. Place the feeder tube with filter deep inside the
full fog fluid tank. Use only high quality, wa-
P. 6
Neo Steam 1500 RGBA - English version
the back panel of the machine.
7. Aluminum die-cast design functioned with
high-effective heating module prevents clog-
ging. Unique design that can be earthed directly
without affecting normal working of the thermo
system and DMX control circuit. There won't be
danger of accidental human body's electric
shock.
8. High output fog machine, approx. 40,000 cu.ft/
min output.
9. Electronic Thermo Sensing (ETS) – electronic
heater stay hot at all times between fog blasts.
10. Direct thermal protection.
11. Operate by wireless controller (DZ-2). Simple and
humanized design makes Steam 1500 RGB easier
for use.
ter-based fog fluid.
5. Firmly attach the remote control mechanism
to socket on the back of the unit. Or use DMX
control setting on the back of the unit.
6. Plug mains power cord from the fog machine
into appropriate power supply socket. Wait
about 9 minutes for heating element to heat up.
7. Refer to your controller manual for operation
details. (Appendix A )
8. If fog is emitted continuously for a long time,
the heating element temperature may drop,
shutting off fog production. If so, please do not
activate for emission. Wait briefly. When the
heating element temperature rises, fog emis-
sions can be resumed.