Lenco CR-2003 Manual Del Usuario página 43

Hiss in FM mode.
Alarm does not work.
Unable to do DLNA
streaming.
Electro-Magnetic
Interference.
System freezes
suddenly.
station no longer transmits – ask the provider
for information.
4. The link of manual added station is not
correct, make sure it is correct and re-enter.
1. Check/move the FM antenna.
2. Move the radio.
1. Switch on the alarm.
2. Due to the volume setting, refer to the
solutions of "No sound".
3. The source of alarm was set to be station but
there is no network connection. Change the
source of alarm or reconfigure the connection.
1. Check the connection of the network,
CR-2003 and your device need to be in the
same network; and test if the network in
good condition.
2. Make sure the settings on your device are
correct.
1.The normal function of the product may be
disturbed by strong Electro-Magnetic
Interference. If so, simply reset the product to
resume normal operation by following the
instruction manual. In case the function could
not resume, please use the product in other
location.
1. The radio is overloaded, reboot the unit.
43